Honeywell HCC-745NTW/PTW User Manual
Page 18

- 18 -
<< SPECIAL FUNCTION >>
①
MIRROR
②
SHARPNESS
③
NEGATIVE
④
FREEZE
⑤
BAUDRATE
⑥
PROTOCOL
⑦
F.OSD DISP
RETURN
OFF
10
OFF
OFF
9600bps
DEFAULT
ALL
5.12 SPECIAL FUNCTION
①
Mirror Mode
: Mode ON is Mirror Mode, OFF is general screen state.
MIRROR OFF → H MIRROR → V MIRROR → FLIP . . . .
②
Sharpness
: Use to change the contour of Scene.
SHARPNESS 0 ~ 15
③
Negative Mode
: Use for Positive and Negative mode. ON is Negative mode,
OFF is Positive mode namely general screen state.
NEGATIVE OFF → ON → ….
④
Freeze Mode
: It pause current image. ON is to stop, OFF is to return
to normal state.
FREEZE ON → OFF → ….
☞
caution
1. Freeze image is not saved after Power OFF / ON .
That’s why it doesn’t have memory for saving.
⑤
BAUD RATE
: Use to communicate through RS232C, RS485, RS232TTL .
BAUDRATE 4800bps → 9600bps → …. → 312kbps
☞
caution
1. When Baud Rate of Camera and external system is not
same, it happens Communication fail.
⑥
PROTOCOL
: Use to communicate through RS232C, RS485.
PROTOCOL DEFAULT → VCL → KD6 → P/D → ....
⑦
Function OSD Display
OSD DISP ALL → NONE → TOP → BOTTOM → ....
ALL : Whole Function OSD display
( Focus Mode, Key state, Zoom Ratio, ID )
TOP : Only Upper OSD display ( Focus Mode, key state )
BOTTOM : Only Lower OSD display ( Zoom Ratio, ID )
NONE : Whoe Function OSD display not.
5.13 FACTORY DEFAULT
: All changed data are returned to shipping condition.
For Initialization, select “RESTORE FACTORY SETTING” and
push MENU key.
☞
caution
1. Keep in mind that this mode return all changed data to
shipping condition.
2. Some menu as ID,TITLE, etc are not initialized.
<< RESTORE DEFAULT >>
①
RESTORE FACTORY SETTING
RETURN
<< EXIT MENU >>
①
SAVE AND EXIT
②
EXIT
RETURN
5.14 EXIT MENU
①
SAVE AND EXIT
: Exit OSD MENU with saving all changed data.
②
EXIT
: Exit OSD MENU withoout saving all changed data.