Hotpoint EG1000EX - Manual (Page 33)

WARNING - THIS APPLIANCE MUST BE EARTHED
Your cooker should have been checked to ensure that the voltage corresponds
with your supply voltage, which is stated on the data badge fitted on the rear
panel.
The cooker must be connected by a contractor/engineer who is registered with
the National Inspection Council for Electrical Installation Contracting (NICEIC),
to a suitable double - pole control unit with a minimum rating of 30A and a
minimum contact clearance of 3mm, which should be fitted adjacent to (but
not above) the cooker, in accordance with IEE regulations.
The power supply cable should conform to BS6004 with a conductor size of
4mm
2 .
The control unit should be easily accessible in the event of an emergency.
This appliance conforms to EN55014 regarding suppression of radio and
television interference.
Access to the mains terminals is gained by removing the rear access cover.
The mains cable must pass through the cable clamp adjacent to the terminal
block. Sufficient cable should be used to allow the cooker to be pulled out for
servicing.
INSTALLATION & OPERATIONAL CHECKS
After installation, check for gas soundness.
Fit the hotplate burner bodies, burner port rings, enamelled discs and pan
supports referring to the instructions for use where necessary.
1. Check that the hotplate burners ignite correctly and burn with a steady
flame. Check for a steady flame on the low setting.
2. Check that with the left hand oven set at 230˚C, the oven fan operates
and the oven heats up.
3. Check that with the right hand oven set at 230˚C, the oven heats up.
4. Check that the twin grill heats up.
5. Check that the warming drawer heats up.
6. Check operation of clock.
7. Check operation of the ceramic plate (model EG1000EX only).
Instruct the user on the operation of the cooker.
33
Electrical Connection