Honeywell Chronotherm IV T8601D - Manual (Page 6)

T8601D CHRONOTHERM® IV DELUXE PROGRAMMABLE THERMOSTATS
69-1410—2 6
Table 3. Thermostat Installer Setup Options.
Select
Installer Setup
Number
(Press Time !
key to change)
Factory-Setting
Other Choices
(Press ! or " key to change)
Actual
Setting Display Description Display Description
Not used 1 — — — — —
Fan operation a 2 0 Conventional application
where equipment control
fan operation in heat mode 1 Heat pump or electric
heat applications where
thermostat controls fan
operation in heat mode
Not used 3 — — — — —
Heating cycle
rate 4 6 6—6 cph used for
conventional heat.
1, 3 or 9 1—1 cph used for radiant
floor heat, gravity
system
3—3 cph used for hot
water systems or high
efficiency furnaces
9—9 cph used for electric
heat systems
Not used 5 thru 11 — — — — —
System setting
adjustment 12 1 Manual changeover. 0 or 2 0—Auto changeover
2—Auto only
Adaptive
Intelligent
Recovery™
control 13 0 Adaptive Intelligent
Recovery™ control is
activated (system starts
early so setpoint is reached
by start of program period) 1 Conventional recovery
(system starts recovery at
programmed time)
Degree
temperature
display 14 0 Temperature is displayed
in °F 1 Temperature is displayed
in °C
Not used 15 — — — — —
Clock format 16 0 12-hour clock format 1 24-hour clock format
Not used 17 and 18 — — — — —
Extended fan
operation in
heating
a
19 0 No extended fan operation
after the call for heat ends 1 Fan operation is
extended 90 seconds
after the call for heat
ends
Extended fan
operation in
cooling
a
20 0 No extended fan operation
after the call for cool ends 1 Fan operation is
extended 90 seconds
after the call for cool ends
Not used 21 thru 23 — — — — —
Outdoor
temperature
display (select
models) 24 0 No outdoor temperature is
displayed 1 Outdoor temperature is
displayed. Needs a
C7089B1000 Outdoor
Sensor to operate
Not used 25 thru 29 — — — — —
Deadband 30 3 Heating and cooling
setpoints can be set no
closer than 3°F (1.5°C) 4 thru 10 Heating and cooling
setpoints can be set no
closer that chosen value:
4—4°F (2°C)
5—5°F (2.5°C)
6—6°F (3°C)
7—7°F (3.5°C)
8—8°F (4°C)
9—9°F (4.5°C)
10—10°F (5°C)
Not used 31 and 32 — — — — —
Minimum off
time for the
compressor 33 5 5 minute minimum off- time
for the compressor. 0 thru 4 Minimum number of
minutes (0 thru 5) the
compressor is off
between calls for the
compressor