Hoover WindTunnel Wind Tunnel Canister Cleaner with Powered Hand Tool - Manual (Page 3)

3
Unpack cleaner from carton and iden-
tify the parts shown. Remove and
dispose of cardboard packing.
A. Canister cleaner
B.WindTunnel™ powered nozzle
C. Extra paper bag (one bag is
installed in cleaner)
D. Extension wands and hose
A B
C
D
1-1
1. Assembling cleaner
This cleaner was inspected and packaged carefully before being shipped
from the factory. If you should happen to need assistance during assembly
or operation, call
1-800-944-9200 for an automated referral of authorized service
outlet locations (U.S. only) OR
1-330-499-9499 to speak with a representative in the Hoover
Consumer Response Center. OR
Visit us online at www.hoover.com to find the service
outlet nearest you (click on the “Service” button).
Carton contents
Connect hose, wands and nozzle
1-2
1-3
A
Connect hose
With hose toward front of cleaner, push
hose connector into opening in bag lid.
When hose is attached properly, hose
cord plug will reach to receptacle on
cleaner.
Insert plug as deeply into the recepta-
cle as possible. Latch (A) will automati-
cally fasten. Cleaner will not operate
unless plug is inserted into receptacle.
To disconnect hose, first remove hose
cord plug from receptacle while pulling
out on latch. Then, depress buttons
(shown in Fig.1-2 by arrows) on hose
connector and pull up.
Note: The flexible hose contains elec-
trical wires for connection to the
power nozzle and should not be used
if damaged. The wires should not be
seen through the outer skin.
B
Attach nozzle and wands
The wand with the storage clip connects
to the power nozzle.
Attach it to power nozzle by fitting but-
ton projection (B) on nozzle connector
(C) into opening near end of wand. Be
sure nozzle is locked in place.
To release, press down on center of
latch (D) and remove nozzle.
1-4
C
D
Continued ➟