Harbor Freight Tools 92499 - Manual (Page 8)

SKU 92499 For technical questions, please call 1-800-444-3353 PAGE 8
3. Never place objects on top of the Laminator. Always check to make sure the
Cooling Vents on top of the Laminator are not obstructed.
4. Turn off the Laminator and unplug it from its electrical outlet before
removing any jammed paper or film.
5. The laminating Film (not included) must always be approximately 1/4” longer
and wider than the objects being laminated.
6. Use a larger size laminating Film if there is no proper size Film available.
After laminating, cut off the excess laminating Film.
7. To avoid jams, always insert the sealed side of the laminating Film first into
the Laminator.
8. Prior to using the Laminator, make sure to read and understand the
instructions and safety warnings as outlined in the manufacturer of the
laminating Film. NEVER attempt to laminate flammable or corrosive
objects.
9. Never leave the Laminator unattended when it is plugged into an
electrical outlet. Make sure to unplug it from its electrical outlet before leaving
the area.
10. Performance of this Laminator may vary depending on variations in local
line voltage. Extension cord usage may also affect equipment performance.
11. WARNING! The warnings, precautions, and instructions discussed in this
instruction manual cannot cover all possible conditions and situations that may
occur. It must be understood by the operator that common sense and caution
are factors which cannot be built into this product, but must be supplied by the
operator.
SAVE THESE INSTRUCTIONS