Harbor Freight Tools 92499 - Manual (Page 7)

5. If you are using one extension cord for more than one tool, add the nameplate
amperes and use the sum to determine the required minimum cord size.
(See Figure B.)
6. If you are using an extension cord outdoors, make sure it is marked with the
suffix “W-A” (“W” in Canada) to indicate it is acceptable for outdoor use.
7. Make sure your extension cord is properly wired and in good electrical condition.
Always replace a damaged extension cord or have it repaired by a qualified
electrician before using it.
8. Protect your extension cords from sharp objects, excessive heat, and damp or
wet areas.
SYMBOLOGY
SPECIFIC SAFETY RULES
1. Maintain labels and nameplates on the Laminator. These carry important
information. If unreadable or missing, contact Harbor Freight Tools for a
replacement.
2. Always place the Laminator on a dry, flat, level, sturdy non flammable
work surface capable of supporting the weight of the Laminator and any
additional accessories. Make sure to place the Laminator in a location that
is out of reach of children.
V ~
A
xxxx/min.
no No Load Revolutions
Per Minute (RPM)
Double Insulated
Canadian Standards
Association
Underwriters
Laboratories, Inc.
Volts Alternating
Current
Amperes
FIGURE C
SKU 92499 For technical questions, please call 1-800-444-3353 PAGE 7
4. When using more than one extension cord to make up the total length, make
sure each cord contains at least the minimum wire size required.
(See Figure B.)