Harbor Freight Tools Pacific Hydrostar 2" or 3" dirty water pump 65322 - Manual (Page 16)

SKU 65322 or 65323 For technical questions, please call 1-800-444-3353. Page 16
Storage
engine Storage Preparation
Wait for engine to cool, then clean 1.
engine with clean cloth.
When the equipment is to remain idle
2.
for longer than 20 days, prepare the
engine for storage as follows:
Change engine oil and empty fuel a.
tank.
Either leave fuel tank empty or
b.
refill fuel tank with fresh unleaded
gasoline mixed with a fuel stabilizer
intended for long term engine stor-
age (not included). After filling, run
engine for about 3-5 minutes to cir-
culate the treated gasoline through
the carburetor. Wait for engine to
cool before proceeding.
Clean out area around spark plug.
c.
Remove spark plug and pour one
tablespoon of engine oil into cylinder
through spark plug hole.
Reinstall spark plug, but leave spark
d.
plug wire disconnected.
Pull recoil starter to distribute oil in
e.
cylinder. Stop after one or two revo-
lutions when you feel the piston start
the compression stroke (when you
start to feel resistance).
Apply a thin coat of rust preventive oil 3.
to all uncoated metal parts.
Cover and store in a dry, well-venti-
4.
lated area out of reach of children.
Before starting the engine after stor-
5.
age, keep in mind that untreated gas-
oline will deteriorate quickly. Drain
the fuel tank and filter, and change
to fresh fuel if untreated gasoline has
been sitting for a month, if treated
gasoline has been sitting beyond the
fuel stabilizer’s recommended time
period, or if the engine does not start
properly.
Pump Storage Preparation
Be sure the pump has been drained. 1.
Remove the Access Plug (15) on the
bottom of the Pump Housing (10).
Allow the water to drain, then replace
the plug.
Check the pump for any damage be-
2.
fore storage. Wipe with a clean cloth.