Pre-operation checks – Harbor Freight Tools Pacific Hydrostar 2" or 3" dirty water pump 65322 User Manual

Page 11

SKU 65322 or 65323

For technical questions, please call 1-800-444-3353. Page 11

Pre-oPeration cHecKS

caution: Failure to add oil to the Engine

before use will damage the Engine

and void the factory warranty. En-

gine oil is the key factor in engine

performance. Do not use Engine oil

with additives. Do not use two-stroke

gasoline-oil. Using these products will

shorten Engine life. See Specifica-

tions on page 6 for recommended oil

type.
check that all mounting nuts and

bolts are tight.
check oil level

(See illustration be-

low.) If needed, add oil and wipe Dip-

stick area. Unscrew the oil Dip Stick

and wipe clean. Insert the Dip Stick

back into the hole without screwing

it in. Remove it again and check the

oil level. Full is indicated by oil on the

Upper Level mark.
If adding oil, use a siphon to avoid

spilling the oil. Do not overfill.
When full, carefully screw the plastic

Dip Stick back into the metal Engine

crankcase to avoid stripping the plas-

tic threads on the Dip Stick.

check air Filter.

(See illustration

below.) Unscrew Air Filter Wing Nut

and remove the Air Filter Cover and

Filter Elements. If dirty or dusty, clean

(refer to the Maintenance Section).
Caution: To avoid damaging the En-

gine, never run it without the Air Filter

Assembly attached.
check fuel level.

Remove the fuel

Filter Cup, clean and replace it before

filling.

Fill the Fuel Tank, outdoors, with up

to 0.95 of a gallon of unleaded gaso-