HP AA-RTDRB-TE - Manual (Page 42)

Configuring the Product
42 Embedded Web Server User Guide
Enabling or Disabling the CLI
Perform this procedure to enable or disable the state of the product’s command
line interface (CLI). To change the CLI state:
1. Choose Configure from the navigation panel.
2. Click the Management tab and the CLI tab. The CLI tab view displays
( Figure 12 ).
Figure 12: Disabling the CLI
3. Perform one of the following steps as required:
a. Click Enable to activate the CLI. The following message displays: Your
changes to the CLI enable state have been
successfully activated
.
b. Click Disable to deactivate the CLI. The following message displays:
Your changes to the CLI enable state have been
successfully activated
.