HP AA-RTDRB-TE - Manual (Page 40)

Configuring the Product
40 Embedded Web Server User Guide
Configuring SNMP
Perform this procedure to configure community names, write authorizations,
network addresses, and user datagram protocol (UDP) port numbers for up to six
SNMP trap message recipients. A trap recipient is a management workstation that
receives notification (through SNMP) if a switch event occurs. To configure
SNMP trap recipients:
1. Choose Configure from the navigation panel.
2. Choose the Management tab. The Management and SNMP tab views
display ( Figure 11 ).
Figure 11: Configure SNMP parameters tab view
a. Click the Enable Authorization Traps field to enable authorization trap
messages to be sent to SNMP management stations when unauthorized
stations try to access SNMP information from the product.
b. For each trap recipient to be configured, type a community name of 32
alphanumeric characters or less in the Community Name field. The
community name is incorporated in SNMP trap messages to prevent
unauthorized viewing or use.