Harbor Freight Tools 95504 - Manual (Page 7)

SKU 95504 Page 7
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM
IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER
NOR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO
THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PROD-
UCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT.
IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT
ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTI-
FIED AND LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES
ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL
PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER
INSTALLATION OF REPLACEMENT PARTS THERETO.
Adjust the Wheel Guard so that it provides a shield between you (the user)
and the material you are working on. The Wheel Guard must be in
place at all times when using the Angle Grinder.
6. Grip the Handle [35] with your left hand and the Housing [25] with your right
hand. Depress the Lever [31] with your right hand to turn the tool on. Allow
the motor to reach its full speed before grinding. Make sure the grinding
wheel is rotating evenly and all parts appear to be working properly. Always
maintain a firm grip with both hands when operating this tool.
7. To begin cutting or grinding, approach the material at an angle between
15 and 30 degrees to the wheel. Maintain that angle until you are finished
cutting/grinding. Do not force the wheel or apply too much pressure. If the
wheel slows down as you work with your material, you are applying too
much pressure.
8. Once you have turned the Grinder off, continue to hold onto the tool with
both hands until the motor stops completely before you set it down.
Maintenance and Troubleshooting
Before use, add a few drops of light tool oil into the air inlet (26). See assem-
bly diagram on page 8. If the tool stops turning, the Rotor Blades (21) may be
gummed up or damaged. You can remove and clean them or replace them if
needed. See page 8. Call 1-800-444-3353 to order replacement parts.
Caution: Always disconnect the Air Grinder from its compressed air
supply source before performing any cleaning, servicing, or maintenance.
REV 09l