Harbor Freight Tools 95504 - Manual (Page 5)

SKU 95504 Page 5
2. All accessories must be rated for at least the RPM speed recommended on
the tool’s warning label. Wheels and other accessories running over rated
speed can fly apart and cause injury.
3. For safest operation, it is recommended that only these accessories be used
with this product: Abrasive Cut-Off Discs and Wheels, Flap Wheels, Wire
Brushes, Wire Wheel Brushes.
4. Always use an approved and proper guard when using the above mentioned
accessories. Each accessory must have the correct arbor size and must
fit properly on the Gear Shaft. Make sure accessories are tightened down
securely.
5. Always disconnect from power source before adding or removing
accessories. Use a cloth or glove to protect hands from abrasion.
6. The Handle must be used at all times to maintain complete control of the
tool. Two-handed operation is required at all times.
WARNING: Never install a carbide tipped or steel circular saw blade for use
with this Angle Grinder! Never install a wood carving blade, carving disc with
saw chain cutters, or a cutting carving disc on this Angle Grinder!
Unpacking
When unpacking, check to make all parts listed on Page 8 are included. If any
parts are missing or broken, please call Harbor Freight Tools at the number on
the cover of this manual.
Air Connection
Note: Air Compressor is not supplied. You will need an Air Compressor with a
minimum rating of One Horsepower, 6 SCFM delivery at 90 PSI, and a 12 Gallon
Air Tank.
You may use Couplings (not supplied) as shown in the Diagram above. Do not
connect Couplers directly to the Air Inlet. Doing so will increase the overall bulk of
the tool and strain the Inlet Threads.
1. Be sure to follow all safety precautions as listed on Pages 2-5 of this manual.
Angle
Grinder
REV 09l