How to use the core bit (for light load) – Hitachi DH24PB2 User Manual

Page 15

English

6. Using depth gauge (Fig. 12)

(1) Loosen the knob on the side handle,

and insert the depth gauge into the
mounting hole on the side handle.

(2) Adjust the depth gauge position ac-

cording to the depth of the hole and
tighten the knob bolt securely.

7. How to use the drill bit (taper shank)

and the taper shank adaptor.

(1) Mount the taper shank adaptor to the

rotary hammer. (Fig. 13)

(2) Mount the drill bit (taper shank) to the

taper shank adaptor. (Fig. 13)

(3) Turn the switch ON, and drill a hole in

prescribed depth.

(4) To remove the drill bit (taper shank),

insert the cotter into the slot of the taper
shank adaptor and strike the head of
the cotter with a hammer supporting
on the rests. (Fig. 14)

HOW TO USE THE CORE BIT (FOR LIGHT LOAD)

When boring penetrating large hole use the core bit (for light load). At that time use
with the center pin and the core bit shank provided as optional accessories.

1. Mounting

CAUTION:

⅜ Be sure to turn power OFF and disconnect the plug from the receptacle.

Fig. 13

Drill Bit

Taper shank
Adaptor

Front Cap

Grip

Cotter

Rests

Taper Snank Adaptor

Fig. 14

Mounting Hole

Depth Gauge

Knob on Side
Handle

Fig. 12