beautypg.com

Operator safety – Hayter Mowers Powertrim 407F User Manual

Page 6

background image

OPERATOR SAFETY

6

1739579

2.

Never run the engine indoors or inside a

closed area. The exhaust fumes are

dangerous, containing CARBON MON-

OXIDE, an ODORLESS and DEADLY

gas.

3.

Never make adjustments or repairs with

the engine running. Disconnect the

spark plug wire, and keep the wire away

from the plug to prevent accidental start-

ing. Always wear eye protection when
you make adjustments or repairs.

4.

Check the trimmer head and engine

mounting bolts at frequent intervals for

proper tightness.

5.

Keep all nuts and bolts tight and keep

equipment in good condition. Check

mounting hardware on trimmer head ev-

ery time you change trimmer line and

prior to each use.

6.

Never tamper with safety devices.

Check their proper operation regularly.

7.

When servicing or repairing the ma-
chine, do not tip the machine over or up

unless specifically instructed to do so in

this Manual. Service and repair proce-

dures can be done with the machine in

an upright position. Some procedures

will be easier if the machine is lifted on a
raised platform or working surface.

8.

To reduce fire hazard, keep machine

free of grass, leaves, or other debris

build−up. Clean up oil or fuel spillage.

Allow machine to cool before storing.

9.

Stop and inspect the equipment if you
strike an object. Repair, if necessary, be-

fore restarting.

10. Always disconnect spark plug wire be-

fore cleaning, repairing, or adjusting.

11. Do not change the engine governor set-

ting or over−speed the engine.

12. Clean and replace safety and instruction

decals as necessary.

13. To guard against engine over−heating,

always have engine debris filter

mounted and clean.

14. Inspect trimmer before storage. When

not in use, disconnect spark plug lead
and store product indoors in a dry place

locked or otherwise inaccessible to chil-

dren.

15. Use only original equipment or autho-

rized replacement parts.

16. Never replace the cutting lines with met-

al parts.