Havis-Shields DS-DELL-103 - Manual (Page 7)

www.havis.com • 1-800-524-9900 6 7
Installation
1) Install the Mounting Bracket to the Motion Device using (4) 1/4“-20 screws
(Hardware Kit Item 3). Torque screws to 120 in-lbs (13.4Nm) ± 10%.
NOTE: Numerous hole patterns present in Mounting Bracket will accommodate Havis
Motion Devices as well as most competitors’.
2) Lower the Docking Station to the Mounting Bracket as shown and secure with
(4) M5 screws (Hardware Kit Item 4). Torque screws to 25 in-lbs (2.8 Nm) ± 10%.
1/4”-20 Screws
Mounting Bracket
Typical Motion Device Example
(not included)
M5 Screws
NOTE: We recommend applying a drop of medium strength (blue)
thread locking adhesive to the threads of all fasteners.
Cable Management
1) Tip the Docking Station forward to a position that is comfortable to work with.
2) Install all cables that are necessary for computing needs.
3) Use Zip Ties (Hardware Kit Item 1) to strain relieve cables to the Strain
Relief Points at rear of Docking Station.
4) Gather all cables to one side and tie off to unused holes on underside
of Docking Station.
Insert as many zip ties as
necessary to secure cables.