Husqvarna 372XP EPA II - Manual (Page 40)

40 – English
TECHNICAL DATA
Recommended original and replacement bar and chain combinations
These Husqvarna chain saw models are in the ANSI category of saws above 3,8 cu. in. and are not required to comply with low
kickback performance requirements. However, for these models we recommend the following cutting equipment.
Note: For the chains above you are free to choose between 0,050" and 0,058" gauge drive link for the corresponding bar, see the
table below.
Saw chain filing and file gauges
Bar Chain
Length, inch Pitch, inch Gauge, inch Max. nose radius Type Drive link count
15 3/8 1,5 11T
Husqvarna H42,
Husqvarna H48
56
16 3/8 1,5 11T
Husqvarna H42,
Husqvarna H48
60
18 3/8 1,5 11T
Husqvarna H42,
Husqvarna H48
68
20 3/8 1,5 11T
Husqvarna H42,
Husqvarna H48
72
24 3/8 1,5 11T
Husqvarna H42,
Husqvarna H48
84
28 3/8 1,5 11T
Husqvarna H42,
Husqvarna H48
93
0,050"/1,3 mm H46 H47
0,058"/1,5 mm H42 H48
!
WARNING! This chain saw model is capable
of severe kickback that could result in
serious injuries to the user. Do not operate
this saw unless you have extraordinary
cutting needs and experience and
specialized training for dealing with
kickback. Saws with significantly reduced
kickback potential are available. Always use
the safest saw and cutting equipment
applicable to your cutting need.