beautypg.com

Fitting the j-handle, Adjusting the harness, Assembling the cutting equipment – Husqvarna 335L User Manual

Page 6: Fitting the guard extension, Assembl y

background image

6

English

ASSEMBL

Y

Fitting the J-handle

Clip the loop handle onto the shaft. Note that the loop
handle must be fitted between the arrows on the shaft.

Slide the spacer into the slot in the loop handle.

Fit the nut, knob and screw. Do not overtighten.

Attach the J-handle to the loop handle using the three
screws, as shown.

Now adjust the trimmer to give a comfortable working
position. Tighten the bolt/knob.

Adjusting the harness

Put on the har

ness and hang the machine from the support

hook. Now make a final adjustment so that the machine is in
a comfortable working position when it hangs from the
harness.

Assemb

ling the cutting equipment

Fitting the guard extension

CA

UTION!

The guard extension shall always be fitted when

using the trimmer head/plastic blades and combination
guard. The guard extension shall always be removed when
using the grass blade and combination guard.

Enter the guard extension guide in the slot of the combination
guard. Then click the guard extension into position on the
guard with the four quick-fasteners.

The guard extension is removed easily using the spark plug
spanner, see illustration.

!

W

ARNING! Only grass blades/grass cutters

or trimmer heads/plastic blades may be used
when the J-handle is fitted. Saw blades must
never be used with the J-handle.

!

W

ARNING!

When fitting the cutting attachment it is
extremely important that the raised section
on the drive disc/support flange engages
correctly in the centre hole of the cutting
attachment. If the cutting attachment is fitted
incorrectly it can result in serious and/or
fatal personal injury.

!

W

ARNING! Never use a cutting attachment

without an approved guard. See the chapter
on Technical data. If an incorrect or faulty
guard is fitted this can cause serious
personal injury.