Resetting the terminal, Soft reset (warm boot), Hard reset (cold boot) – Honeywell DOLPHIN 9951 User Manual
Page 40: Suspend mode, Hardware maintenance, Resetting the terminal -18, Suspend mode -18, E terminal in suspend mode; see
3 - 18
Resetting the Terminal
There are two types of system resets: a soft and a hard reset.
Soft Reset (Warm Boot)
A soft reset re-boots the device without losing RAM data. You would perform a soft reset when
• the terminal fails to respond.
• after installing some software applications.
• after making changes to certain system settings, such as network cards.
1.
On the 56-key keyboard, press and hold the CTRL
+ SFT
keys for approximately 5
seconds.
On the 43-key keyboard, press and hold the CTRL
+ NUM
keys for approximately 5
seconds.
2.
The decode and scan LEDs flash for approximately three seconds as the terminal resets.
3.
When the reset is complete, the Today screen displays.
Hard Reset (Cold Boot)
A hard reset resets the operating system, restores the terminal back to factory defaults, and resets the
terminal after a bootloader, keyboard, and kernel upgrade.
A hard reset erases all of the data stored in RAM memory and all RAM installed applications!
1.
Press and hold the CTRL
+ ESC
keys for approximately 5 seconds.
2.
The decode and scan LEDs light for approximately 3 seconds.
3.
The terminal re-initializes; see
Initialize the Mobile Computer
on page
2-8.
Suspend Mode
The terminal goes into Suspend Mode automatically when the terminal is inactive for a programmed
period of time. You can program this time on the Advance tab of the Power system setting; see
To put the terminal into Suspend Mode manually, press the Power key
and the screen goes blank.
To wake the terminal from Suspend Mode, press the Power
or SCAN keys
.
Hardware Maintenance
When needed, clean the image engine window and the LCD display with a clean, non-abrasive, lint-free
cloth. The terminal can be cleaned with a damp cloth.
CTRL
SFT
CTRL
NUM
!
CTRL
SFT
SCAN