Humax Digital Set-Top Box - Manual (Page 14)

If you press the HELP ( ) button while the I-Plate is displayed,
the detailed description of the event will be displayed on the help
window instead of help messages. If there is no available data for
the detailed description on the air, the help message is displayed on
the help window instead.
There are several ways to change a service.
• Use the NUMERIC buttons: key in the service number using the
NUMERIC buttons and press the OK ( ) button. If the OK ( )
button is not pressed, the service is automatically changed to the
service number keyed in after about 5 seconds.
• Use the buttons: the service is changed up/down
sequentially if the button is pressed.
• Use the buttons: the service is changed up/down
sequentially if the button is pressed.
• Use the service list or Guide list: refer to the following description.
• Use the RCL
( ) button: return to the latest viewed service
when the RCL ( ) button is pressed.
There are two types of service, TV and RADIO.
To switch between them, press the TV/RADIO button.
To change a service in the service list or guide list, proceed as
follows:
1. Activate the service list or guide list.
(Refer to the following GB15, 17 pages on how to activate them)
2. Select the desired service using the button.
3. Press the OK
( ) button, and the service is changed to the
desired one.
The TELETEXT ( ) icon appears on the I-Plate if there is
available teletext data in the service.
(
NOTE: The TV supports the teletext decoder internally for
watching it, since the teletext data is decoded by the TV.)
To adjust the volume level, use the button or the button.
To mute the audio, press the MUTE
( ) button. To recover the
audio level, press the MUTE ( ) button again, or the ,
button.
Changing Services
Volume Control
Teletext Service
GB13