Honeywell MAGIC STAT MS3000 - Manual (Page 12)

RECALIBRATING THE THERMOSTAT
TEMPERATURE ADJUSTMENT
Your thermostat should normally display the correct room SCREW
temperature. display,
stat can as follows:
❑ Make sure the thermostat has been on for at least 2 hours.
❑ Place an accurate room thermometer near the left side of the
thermostat. Be careful not to touch thermometer or breathe on it.
❑ Open the left door of the thermostat.
•l Locate the temperature adjustment screw.
❑ Use a flat blade screwdriver to turn the screw slightly clock-
wise to increase, or counterclockwise to decrease the
indicated emperature.
❑ After each turn, allow the thermostat to stabilize about 30 seconds.
❑ Continue this procedure until the thermostat has the same temperature reading as the room
thermometer.
29 69-8026—2
THE “WAITING” INDICATOR DURING AIR CONDITIONING
To prevent possible damage to your compressor, and to maximize the efficiency of your air
conditioning system, no controls can be activated for approximately 6 minutes after the com-
pressor shuts off. If you try to override the temperature during this time, the display will show
WAITING until the 6 minutes pass.
30
YOUR PERSONAL PROGRAM
Use the table below to plan your schedule before you begin programming. If you are pro-
gramming a different schedule for each day of the week, fill out-a different table for each day.
Desired Temperature b
Typical Activity a Your Start Time Heating Cooling
Wake up
Leave home
Arrive home
After dinner
Retire
Extra Nighttime
Set Point (see
page 13)
a You may program between 2 and 6 typical activity times.
b You may program up to 8 different heating/cooling temperature combinations over the duration
of a week.
31 69-8026—2