Hunter Fan 41535-01 - Manual (Page 5)

41535-01 10/8/2001 5 © 2001 Hunter Fan Company
Step 11: Operation of Fan
A. Turn electrical service on at main panel.
B. Switch operates in this sequence: “high,” “medium,”
“low,” “off.” Pull chain slowly to operate. Also, release
the chain slowly so as to prevent chain from flying up
into blades, possibly resulting in damage to blades or
pull chain. The breakaway connector is designed to
separate from the chain at a predetermined force. If
this separation occurs, simply reinsert connector. It can
be reused again and again.
C. Motor is electrically reversible. When first operating fan,
determine direction of air flow. If you wish to change
direction, switch fan off and allow to stop. Slide revers-
ing switch to the opposite position and switch fan back
on.
1. Nothing happens; fan does
not move.* 1. Power turned off or fuse blown.
2. Loose wire connections or wrong con-
nections.
3. Motor reversing switch not engaged.
4. Pull chain switch not “on”.
5. Rubber shipping blocks not removed.
1. Turn power on or replace fuse.
2. Loosen canopy, check all connections
(turn power off while checking).
3. Push switch firmly to one side or the other.
4. Pull switch chain.
5. Remove shipping blocks.
1. Blade irons loosely screwed to motor.
2. Blade screwed loosely to blade iron.
3. Blade cracked.
4. Non-approved speed control being
used.
1. Tighten screws until snug.
2. Tighten screws.
3. Replace all four blades.
4. Change to approved speed control.
2. Noisy operation.
3. Excessive wobbling. 1. Unbalanced blades.
2. Fan too close to vaulted ceiling.
3. Loose blades or blade brackets.
4. Fan not secure on hanger assembly.
1. Use balancing kit.
2. Lower or move fan.
3. Tighten all screws.
4. Turn power off, support fan very carefully,
loosen canopy and hang correctly.
Problem Probable Cause Solution
Troubleshooting Guide
* If blades will not turn by hand, contact your nearest service representative.
When switching from medium to low speed, you may notice some fan wobble. When fan speed stabilizes at low speed,
wobble will disappear. If you have checked the above problems and still have trouble, call 901-248-2222.