Hunter Fan 41535-01 - Manual (Page 3)

41535-01 10/8/2001 3 © 2001 Hunter Fan Company
Step 6: Final Wiring
A. Connect electrical supply leads to the leads from mo-
tor, using approved connectors. See Figure 9.
1. Connect black electrical supply lead to the black motor
lead and the black with white stripe motor lead (see
note).
2. Connect the white electrical supply lead to the white
motor lead.
3. Connect the ground wire to the green leads.
NOTE: If a separate wall switch will be used to control a light-
ing accessory, connect the black wire with a white stripe to the
wall switch lead, following wiring instructions included with
the accessory. The wall switch must be acceptable for use as a
general-use switch.
Caution: No bare wire or wire strands should be vis-
ible after making connections.
B. After making the wire connections, the wires should
be spread apart with the white and the green wires on
one side of the outlet box, and the black and black/
white wires on the other side of the box. The splices
should be turned upward and pushed carefully up into
the outlet box.
NOTE: If the wires are not pushed up into the outlet box,
they could strike the motor when it operates.
Step 8: Attaching and Balancing the
Blades
A. Attach wood blades to blade brackets using (3) screws
for each blade. See Figure 11. If your blades have
large holes you must first insert the rubber grommets
into the holes. See Figure 12.
NOTE: Grommets are usually assembled by hand. If you use a
tool make certain you do not damage the grommet or blade when
inserting the grommets.
Next, assemble the blade to the blade bracket. Make
sure all screws are tight to prevent vibration or wob-
bling. A cavity in the Styrofoam packaging has been
provided to nest the parts in during assembly to as-
sure correct alignment of parts. Even when the screws
are tight the blades may seem to be loose. This is nor-
mal when using grommets and will not be a problem.
Grommet
Fan
Blade
FIGURE 12
LOCKING
SCREWS
Step 7: Finish Fan Assembly
A. Using two 8-32 by approximately 5/8” long screws from
sack parts, thread the plastic hanger locking screws
into the back of the hanger bracket. See Figure 9.
The screws should be driven all the way into the bracket
and tightened. The screws are located just above the
plastic hanger and prevent the motor from twisting when
the blades are assembled
Check and make sure all wiring is tucked up into the outlet
box.
B. Place the fan housing over the motor assembly and
fasten the housing to the ceiling plate using the four
screws provided (two into each side). See Figure 10.
Check and make sure the motor clears the opening in the
bottom of the housing.
FIGURE 11
ASSEMBLY
SCREWS
FAN HOUSING
FIGURE 9
FIGURE 10