Step 5: hanging of motor, Step 4: installation of ceiling plate – Hunter Fan 41535-01 User Manual

Page 2

41535-01 10/8/2001

B. Bring electrical cable into the outlet box and attach with

an approved connector. Make certain that wiring meets
all national and local electrical codes. Wire leads should
extend at least 6" beyond outlet box for ease in mak-
ing connections. See Figure 3.

Step 5: Hanging of Motor

Caution: Do not lift motor by wires.

A. Lift the motor and insert the plastic hanger into the open-

ing in the front of the hanger bracket. See Figure 7.
Make sure none of the wires are trapped between the
plastic hanger and the inside of the hanger bracket.

B. Rotate the motor and plastic hanger assembly until the

lower half of the plastic hanger fits into the square open-
ing in the bottom of the metal bracket. Check the as-
sembly by trying to rotate the motor and plastic hanger
assembly. When properly installed the upper part of
the plastic hanger will sit flat inside the hanger and the
assembly will not rotate. See Figure 8.

Caution: Make sure plastic hanger cannot rotate in
metal bracket. Failure to check this could result in the
motor falling.

NOTE: The green ground wire attached to the plastic

hanger should face the opening in the front of the metal
hanger bracket.

Step 4: Installation of Ceiling Plate

A. Install the four (4) rubber bushings into the top of the

ceiling plate by inserting the small side of the bushing
into the four holes in the ceiling plate. See Figures 4
and 5.

B. Thread the lead wires through the opening in the top of

the ceiling plate and through the opening in the side of
the hanger bracket. See Figure 6.

Using the two center slots, attach the ceiling plate to the 2

x 4 brace supporting the outlet box. Use (2) #10
woodscrews 3" long for mounting through the outer-
most holes. Drill two pilot holes 9/64" diameter in the 2
x 4 brace for mounting screws. See Figure 6.

NOTE: When attaching the ceiling plate to the outlet box

support, make certain that bushings remain in place.

NOTE: Tighten the ceiling plate mounting screws only

enought to provide slight compression of the bushings.
Do not overtighten.

CONNECTOR

6" MIN. LEAD LENGTH

BUSHING

CEILING PLATE

BUSHING

OUTLET BOX

2 x 4 BRACE

HANGER BRACKET

CEILING
PLATE

FLAT WASHER

MOUNTING
SCREWS

PLASTIC
HANGER

MOTOR

HANGER
BRACKET

HANGER BRACKET

FIT LOWER HALF
OF PLASTIC
HANGER INTO
SQUARE HOLE
IN BOTTOM OF
HANGER BRACKET

FIGURE 3

FIGURE 4

FIGURE 5

FIGURE 6

FIGURE 7

FIGURE 8