HP 5300A - Manual (Page 11)

that have or have had a pre-v3.02 Management Agent kit installed. Failure to
adhere to the guidance with respect to ensuring no WBEM or CPQ$ACUXE
processes are running within the system or OpenVMS cluster environment can
result in incomplete Management Agent kit component delivery.
Array Configuration Utility XE for OpenVMS
• The new B0126 release of the Smart Array Configuration Utility XE is fully
compatible with the HP Insight Management Agents for OpenVMS beginning
with Agent kit version 3.02.
• ACUXE kit version B0105 is not supported with OpenVMS Management
Agent kits versions 3.00 and higher.
• The B0126 kit supersedes the B0105 Array Configuration Utility kit found on
the software media CD-ROM supplied with the KZPDC controller. The PCSI
kit version is B0126 and when extracted is entitled:
— HP-AXPVMS-ACUXE-B0126--1.PCSI
• The B0126 kit is supported under OpenVMS versions 7.3-1 and 7.3-2.
• Installation of the B0126 ACUXE kit should be performed after first installing
or updating the system or cluster environment with the v3.02 (or later)
Management Agents kit.
• Users installing the B0126 kit into a system or cluster environment that has or
has had the ACUXE kit version B0105 previously installed must use an
installation support script, ACUXE_CLEANUP.COM, to perform the utility
installation. This script will ensure that pre-installation conditions are
appropriate before kit component delivery is initiated and prepare the
system/cluster environment for cluster-wide installation of the kit.
The ACUXE_CLEANUP.COM script is packaged as part of the
ACUXE126.EXE
self-extracting archive containing the B0126 ACUXE PCSI kit
and is available from the Smart Array 5300A web site.
After downloading the B0126 kit distribution file and placing it in
SYS$UPDATE, extract the B0126 PCSI kit and the accompanying
ACUXE_CLEANUP.COM script with the following command:
$ RUN ACUXE126.EXE
Release Notes – Smart Array 5300A Backplane RAID Controllers 7