haier WDNS116BBS - Manual (Page 9)

8
English
- Press and hold the SET button to enter SET Mode
- Press a 2nd time to set Clock Hours (Hours flashing)
- Press a 3rd time to set Clock Minutes (Minutes flashing)
- Press a 4th time to set Hot Water Temperature (Heating Level flashing)
- Press a 5th time to set Cold Water Temperature (Cooling Level flashing)
- If nothing is pressed for 8 seconds the display will automatically exit the
Set Function
3. Night Light: Press the Night Light button and the light will turn ON, press it
once more and the light will turn OFF.
4. Hot/+:
- While in Stand-by mode (#1 above), pressing the Hot/+ button will start
the water heater. The Heating Function icon will flash until the default
temperature of 197°F is reached.
- While in Set mode (#2 above), pressing the Hot/+ button will increase
the heating or decrease the cooling settings.
- Press and hold the Hot/+ button for 2 seconds to exit.
5. Cold/-:
- While in Stand-by mode (#1 above), pressing the Cold/+ button will
start the water cooling compressor. The Cooling Function icon will flash
until the default temperature of 44.6°F is reached.
Please Note: If you turn off the Cooling Function, please wait 5
minutes before restarting.
- While in Set mode (#2 above), pressing the Cold/- button will decrease
the heating or increase the cooling settings.
OPERATING INSTRUCTIONS
Setting the Clock
1. Press ON/OFF
00:00 Flashes
2. Press & Hold SET 00:00 hour flash
3. Press HOT/+ or COLD/- to adjust hours and AM/PM 06:00 set hour and
AM/PM
4. Press SET 00:00 minutes flash
5. Press HOT/+ or COLD/- to adjust minutes
06:23 set minutes
6. If nothing is pressed for 8 seconds the display will automatically exit the Set
Function
HOT AND COLD TEMPERATURE SET
1. Press and hold the SET button for 2 seconds to begin Set Mode.
2. Press the Set button 3 times, until Heating Level is flashing.