Henny Penny CF-941 - Manual (Page 15)

Model CF-941
3-6. OPERATION AND Timer Settings
PROGRAMMING
(Continued) To change a timer setpoint, press and hold the desired
timer button, then use the UP and DOWN buttons to
change the time. Releasing the timer button enters the
time into the controls. If “Loc” shows in the display
when the UP or DOWN button is pressed, the controls
must be unlocked before temperature can be changed.
(See Special Program Mode).
When programming the setpoint temperature or
timers, pressing and holding the UP or DOWN
buttons will speed up the displayed digits.
Special Program Mode
1. Turn the POWER switch off. Then press and hold
both the UP and DOWN buttons and turn the
POWER switch back on. Hold in on the UP and
DOWN buttons until SP shows on the display, then
release the UP and DOWN buttons. Display will now
show “ºF” or “ºC”.
2. Press the UP or DOWN buttons to toggle from
“ºC (Celsius), to “ºF” (Fahrenheit).
3. Press and release the SET button. The display will
show “P=U” or “P=L”, which means program
unlock(U) or lock(L). The UP and DOWN buttons
toggle from U to L. The display must show “P=U”
before the temperature or times can be changed.
4. Press and release the SET button 2 times and the
display will show “H=n” or “H=y”, which means
Hours=no(n) or Hours=yes(y). “H=n” means the
timers will time in minutes and seconds, and “H=y”
the timers will time in hours and minutes.
5. Press and release the SET button 3 times and the
display will show “CAL”. To calibrate the
temperature, press and hold the TEMP button,
and use the UP and DOWN buttons to match the
display to the actual temperature.
203 3-5