beautypg.com

Installation procedure, Install the decorative panel, Notice – haier AB212BCBAA User Manual

Page 34: 1)install decorative panel

background image

Notice

If fastening the screws improperly, it may
cause the trouble as Figure 5 shown.
The screw should be fastened properly.
If after fastening the screw, there still is gap
between decorative panel and ceiling, please
readjust the height of the indoor unit (referring
to Figure 6).
If the indoor unit keeps horizontal and the
drain hose is not affected, adjust the height
of the indoor unit through those holes at the
corner of the decorative panel.

Figure 6

Figure 5

1

(1)Install decorative panel

Temporarily hang the hoisting ring opposite to the louver motor of the decorative panel on

the hoisting ring fixing piece (2 pieces) of the indoor unit.
Temporarily hang the other 2 hoisting rings on the hoisting ring fixing pieces at the side of
the indoor unit (be careful not to stick to wire of the louver motor into the sealing material).
Screw all the 4 hexagon screws under the hoisting ring into about 5mm (the decorative
panel will rise).
Twist in the direction as Figure 4 shown, adjust the decorative panel to make it totallycover
the ceiling opening.
Fasten the screw to make the thickness of the sealing material between
decorative panel and the indoor unit compressed to 5~8mm.

2

3

4

5

32

Installation procedure

Install the decorative panel

Figure 4

The position of nozzle

4

2

Hoisting ring

1

3

Louver motor

2

Indoor unit

Ceiling material

5~8mm

Decorative panel

Sealing material

Leakage

Leak air from the roof

Pollution

Moist forming and drop

Gap is not permitted

This manual is related to the following products: