Hoover C1415 - Manual (Page 2)

2
Note: The white switch lock above the ON/OFF
(A) switch helps in the assembly of your cleaner.
Assembly can be continued if the switch lock is miss-
ing. However, do not remove the switch lock until
assembly is completed.
Align upper handle and lower handle as shown.
Place upper (B) and lower (C) handle parts on a flat surface,
aligning rod sections (D). With hands on sides of handle,
push parts together firmly until they “click” and rod sections
lock together.
Step 2 Attach cord
Insert large rectangular end of cord into pocket in bot-
tom of handle, with side marked “UP” visible.
Make sure rectangular end is pushed into the handle
as far as possible.
Slide cord protector (F) toward upper handle (G).
1-2
1-3
B
C
F
E
“UP”
“UP”
G
E
1. Assembling cleaner
It is extremely important to read and
follow all the assembly steps in order.
Carton contents
Remove all parts from carton and
identify each item shown. Make sure
all parts, especially small items, such
as G and F, are located before dis-
posing of cardboard packaging.
A. Upper handle
B. Lower handle
C. Cord
D. Dirt cup assembly
E. Cleaner body
1-1
A
B C
E
F G
H
D
Step 1 Assemble handle
*Do not press against the grey rod extending from the
lower handle shown in Fig. 1-3 (E). Do not push handle
together with hands on ends of sections.
F. Handle bolt and nut pack-
et (One extra nut included)
G. Dirt cup screws (2)
H. Dirt cup support
UP
UP
D
A