beautypg.com

Emission control (exhaust & evaporative) – Echo GT-225i User Manual

Page 6

background image

6

WARNING

Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects away from all

openings.

ALWAys stop engine, disconnect spark plug, and make sure all moving parts have come to a complete stop

before removing obstructions, clearing debris, or servicing unit.

DO NOT start or operate unit unless all guards and protective covers are properly assembled to unit.

NEVER reach into any opening while the engine is running. Moving parts may not be visible through openings.

equIpment

• Check unit for loose/missing nuts, bolts and screws. Tighten and/or replace as needed.

• Inspect shield for damage and ensure that the cut-off knife is securely in place. Replace if either is damaged or miss-

ing.

• Check that the cutting attachment is firmly attached and in safe operating condition.

• Check that front (loop) handle and optional shoulder/waist harness are adjusted for safe, comfortable operation. See

Assembly for proper adjustment.

WARNING

Use only ECHO approved attachments. Serious injury may result from the use of a non approved attachment com-

bination. ECHO, INC. will not be responsible for the failure of cutting devices, attachments or accessories which

have not been tested and approved by ECHO. Read and comply with all safety instructions listed in this manual and

safety manual.

An Emission Control Label is located on the engine. (This is an EXAMPLE ONLY, information on label varies by

engine FAMILY).

WARNING

Check fuel system for leaks due to fuel tank damage, especially if the unit is dropped. If damage or leaks are found,

do not use unit, otherwise serious personal injury or property damage may occur. Have unit repaired by an autho-

rized servicing dealer before using.

PRODUCT EMIssION DURAbILITy (EMIssION COMPLIANCE PERIOD)

The 300 hour emission compliance period is the time span selected by the manufacturer certifying the engine emis-

sions output meets applicable emissions regulations, provided that approved maintenance procedures are followed

as listed in the Maintenance Section of this manual.

e

mIssIon

c

ontrol

(

exhaust

&

evaporatIve

)

EPA 2010 and Later and/or C.A.R.B. TIER III

The emission control system for the engine is EM/TWC (Engine Modification and 3-way Catalyst) and for the fuel tank

the Control System is EVAP (Evaporative Emissions) or N (for nylon tank). Evaporative emission may be applicable to

California models only.