Echo GT-225i - Manual (Page 16)

16
maIntenance Intervals
COMPONENT/SYSTEM
MAINTENANCE
PROCEDURE
SKILL
LEVEL
REQ'D
DAILY OR
BEFORE
USE
EVERY
REFUEL
3 MONTHS
OR 90
HOURS
YEARLY 600
HOURS
Air Filter Inspect/Clean 1 I / C * R*
Choke Shutter Inspect/Clean 1 I / C
Fuel Filter Inspect/Replace 1 I * I / R *
Fuel Cap Gasket Inspect/Replace 1 I * R *
Fuel System Inspect/Replace 1 I (3) I (3)
Spark Plug Inspect/Clean/Replace 1 I / C / R *
Cooling System Inspect/Clean 2 I / C
Muffler Spark Arrestor Inspect/Clean/Replace 2 I / C / R *
Cylinder Exhaust Port Inspect/Clean/Decarbon 2 I / C
Drive Shaft Inspect/Grease 2 I (1)
Gear Housing Grease 2 I (2)
Recoil Starter Rope Inspect/Clean 1 I / C *
Screws/Nuts/Bolts Inspect/Tighten/Replace 1 I *
* All recommendations to replace are based on the finding of damage or wear during inspection.
(2) Apply POWER BLENDX TM every 50 hours of use.
(3) Low evaporative fuel tanks DO NOT require regular maintenance to maintain emission integrity.
MAINTENANCE PROCEDURE LETTER CODES: I = INSPECT, R = REPLACE, C = CLEAN
IMPORTANT NOTE - Time intervals shown are maximum. Actual use and your experience will determine the
frequency of required maintenance.
MAINTENANCE PROCEDURE NOTES:
(1) Apply POWER BLENDX
TM every 25 hours of use.