Echo GT-225i - Manual (Page 13)

G
rass
T
rimmer
O
peraTOr
'
s
m
anual
13
startInG cold enGIne
WARNING
The attachment will operate immediately when the engine starts
and could result in loss of control and possible serious injury. Keep
movable parts of the attachment off the ground and away from
objects that could become entangled or thrown.
WARNING
Never attempt to disassemble this recoil starter otherwise serious
personal injury may result. See your Echo Dealer if the starter
handle will not operate using light pulling force.
1. Stop Switch
Move stop switch (A) away from the STOP position.
2. Choke
Move choke (B) to “Cold Start” (
) Position.
3. Purge Bulb
Pump purge bulb (C) until fuel is visible and flows freely in
the clear fuel tank return line. Pump bulb an additional 4 or 5
times.
NOTE
Energy is stored in the starter spring each time the handle/rope is
pulled. Generally two to six pulls, using light pulling forces, will
store enough energy to engage the starter and spin the engine. Do
not pull the rope out to end stop.
4. Recoil Starter
Lay the unit on a flat area and keep movable attachment parts clear
of all obstacles. Firmly grasp throttle grip with left hand and fully
depress throttle trigger to wide open position. Gently pull recoil
starter handle/rope (D) until engine fires or 2 to 3 engine engage-
ments.
5. Choke
After engine fires or five (5) pulls, move choke lever back to “Run”
( ) position. Hold throttle trigger fully depressed and pull starter
handle/rope until engine starts and runs. Release throttle trigger
and allow unit to warm up at idle for several minutes.
NOTE
If engine does not start with choke in “Run” position after 5 pulls,
repeat instructions 2-5.
6. After engine warm up, gradually depress throttle trigger to increase
engine RPM to operating speed.
c
d
A
B