Locking grid plate to receiver tray – Epson ELPMBATA User Manual
Page 10
INSTALLATION MANUAL
10
Locking Grid Plate to Receiver Tray
1. After the Receiver Tray (E) has been attached to the ceiling and the projector has been attached
to the Grid Plate (F), slide the Grid Plate (F) into the Receiver Tray (E).
Before completely closing the mount, route the cables that are running down the 1-1/2” Pipe (A)
and out the center of the Receiver Tray (E). (See figure 6)
Slide the Grid Plate (F) in while guiding the cables into a slot located in the back of the Grid Plate
(F). (See figure 7)
2. Put the Screw Lock (I) into the Grid Plate (F) and turn clockwise until it is snug.
WARNING: DO NOT OVER TIGHTEN THE LOCK.
CABLE SLOT
figure 6
figure 7
See also other documents in the category Epson Projectors:
- 70c (2 pages)
- MOVIEMATE 72 (70 pages)
- 71c (86 pages)
- 6110I (16 pages)
- 53c (108 pages)
- 480i (259 pages)
- LS47P1 (138 pages)
- EH-TW2800 (64 pages)
- EB-1725 (116 pages)
- EB 1735W (116 pages)
- 21L (21 pages)
- Livingstation HDTV LCD Projection Television LS57P2 (6 pages)
- EB-W10 (2 pages)
- 76C (111 pages)
- 9100i (122 pages)
- Cinema 200+ (80 pages)
- EB-84 (121 pages)
- POWERLITE 1810P (2 pages)
- ANSI LUMENS 2000 (2 pages)
- ELP-3300 (110 pages)
- 7000 (2 pages)
- ELP-800UG (120 pages)
- EB G5200WNL (6 pages)
- 7250 (2 pages)
- 735C (2 pages)
- ELPMBC01 (6 pages)
- 81p (116 pages)
- Z8455WUNL (256 pages)
- ELP-3000 (103 pages)
- ELPLP29 (75 pages)
- 8100i (120 pages)
- 62c/82c (113 pages)
- 2500 Lumens (10 pages)
- 1080 (76 pages)
- 5300 (5 pages)
- DREAMIO EMP-TW700 (60 pages)
- 8500 UB (4 pages)
- DREAMIO EH-TW4400 (66 pages)
- POWERLITE HOME 10+ CPD-1790-4R2 (44 pages)
- BrightLink 450Wi (186 pages)
- 505c (141 pages)
- 810p (120 pages)
- EB-G5350 (131 pages)
- ELPMBPJF (10 pages)