Eiki LC-XB27 - Manual (Page 29)

29
Choose either Computer 1(Analog) or Computer 2 by
pressing the INPUT button on the top control or press the
COMPUTER button on the remote control.
Before using these buttons, correct input source should be
selected through Menu operation as described below.
Press the MENU button to display the On-Screen
Menu. Press the Point
7 8 buttons to move the red
framed pointer to the Input Menu icon.
1
Input Menu
Press the Point ed buttons to move the red arrow
pointer to either Computer 1(Analog) or Computer 2,
and then press the SELECT button.
2
When selecting Computer 1(Analog), RGB input
source will be selected directly.
When selecting Computer 2, the Source Select Menu
will appear. Move the pointer to RGB and then press
the SELECT button. 3
Computer 1
(Analog/Digital)
Video
Computer 2
COMPUTER button
Computer 2
INPUT button
Input Source Selection (RGB : Computer 1(Analog) / Computer 2 )
Direct Operation
Menu Operation
Computer Input
Move the pointer
(red arrow) to
Computer 1
(Analog) and press
the SELECT button.
Input Menu icon
✳ See Note at the bottom of this page.
✳
✳
Remote Control
Top Control INPUT button
COMPUTER button
ON
- OFF
POWER
AUT INPUT
WARNING LA
MENU
SELECT
✔
Note:
•Computer 2 is not displayed when the COMPUTER IN 2 /
COMPONENT IN / MONITOR OUT terminal is set as Monitor out.
(p50)
•Computer 2 (COMPUTER IN 2 / COMPONENT IN /MONITOR
OUT) can accept only RGB signal.
•Wired, Wireless, and Memory Viewer are for the Network function.
Refer to the owner's manual "Network Set-up and Operation"
supplied with this projector or the owner's manual of Memory
viewer (optionally available).
Move the pointer
(red arrow) to RGB.
Input Menu
Move the pointer
(red arrow) to
Computer 2 and
press the SELECT
button.
Input Menu icon
Computer
2
Computer Input
Wired
Computer 1
(Analog/Digital)