Eiki LC-XB27 - Manual (Page 18)

18
Installation
Connecting to a Computer
ON ON
S-VIDEO IN
COMPUTER /
COMPONENT
AUDIO IN
R
VIDEO IN L
(MONO)
(VARIABLE)
AUDIO OUT
COMPUTER IN 1
DVI-I
USB SERVICE PORT RESET
MONITOR OUT
COMPUTER IN 2
/ COMPONENT IN
Cables used for connection
• VGA Cable (Mini D-sub 15 pin)
✽
•DVI-VGA Cable
•USB Cable
• Audio Cables
✽
( ✽ = Not supplied with this projector.)
External Audio Equipment
DVI-VGA cable USB cable
Audio cable
(stereo)
✽
Audio cable ✽
(stereo)
Monitor Output
or
Monitor Input
USB port Audio Output
USB
C O M P U T E R /
COMPONENT
AUDIO IN
AUDIO OUT
(stereo)
Audio Input
COMPUTER IN 2
/COMPONENT IN
/MONITOR OUT
When connecting the cable, the power
cords of both the projector and the
external equipment should be
disconnected from AC outlet.
✔
Note:
•Input sound to the COMPUTER / COMPONENT AUDIO IN
terminal when using the COMPUTER IN 1 / DVI-I and the
COMPUTER IN 2 / COMPONENT IN / MONITOR OUT terminal
as input.
• When connecting the AUDIO OUT to external audio equipment,
the projector's built-in speaker is disconnected.
• When the cable is of the longer variety, it is advisable to use the
COMPUTER IN 1 / DVI-I and not the COMPUTER IN 2 /
COMPONENT IN / MONITOR OUT.
• USB cable connection is needed when operating the computer with
the remote control or using the PAGE ed buttons on the remote
control.
Monitor Output
COMPUTER IN 1/
DVI-I
VGA cable ✽
This terminal is switchable. Set up the
terminal as either Computer input or
Monitor output. (See Page 50.)