Ericsson LBI-38823D - Manual (Page 32)

Sending A Manually Entered Interconnect Call
1. Press the SPC key to put the radio into Special Call mode. The
SYStem field will display "SP" and the GRP (Group) field will display
the last accessed call number from the preprogrammed Special Call
selection. The "S" "PC" icons will also be illuminated while in the
Special Call Mode.
2. Enter the telephone number to be called. The first digit entered will
cause the System field and the 10’s digit in the Group field to blank.
The last digit entered will always be displayed in the 1’s digit of the
Group field. Any previously entered digits will scroll left. Only four
characters will be visible at a time with the leading character scrolling
off the display upon each new key entry.
3. Complete the telephone entry by pressing the * key. The * key indicates
the digits are for an interconnect call. This will not be displayed but a
tone will sound.
4. Press and release the PTT bar to initiate the call. The radio performs
the necessary signalling required to obtain a working channel. When
the signalling is successfully completed the "BSY" flag lights and the
proper DTMF tones will be sent and heard at the speaker.
If the interconnect signalling is unsuccessful, the radio will remain in
the the Special Call Mode and sound the appropriate alert tone(s).
5. When someone answers, press the PTT bar and speak directly into
the microphone. Release the PTT bar as soon as you stop talking.
Messages cannot be received when the PTT bar is pressed.
To recall the last interconnect number entered manually from the
key pad, press and hold the SHFT/CLR button and then press
the RCL key.
NOTE
32