Electrolux EWT704 - Manual (Page 17)

To start the selected
program, press the
“Start/Hold To Pause”
button.
Start/Hold To Pause
Display
(Model: EWT704, EWT904)
Machine In Pause Mode
If you have started your wash and you
wish to stop it for some reason, press
the “Start/Hold To Pause” button
and hold it for 1.2 second to enter
PAUSE mode
You can tell when your washing
machine is in pause mode. The time
remaining is shown then “ ”.
The display showns the following
information:
Estimated time of the selected
program
End Of Program
Alarm Codes
Incorrect Option Selection
After selecting a program, the estimate
time is displayed in hours and minutes
(for example 2.05).
The estimate time is calculated
automatically on the basis of the
maximum recommended load for each
type of fabric.
In the event of operating problems,
some alarm codes can be displayed,
for example (see “Troubleshooting”
and “Troubleshooting fault displays” on
page 26, 27, 28).
When the program is completed the 3
zeros will flash.
If an option which is not compatible
with the set wash program is selected,
the message “ ” is displayed for
about 2 seconds and 3 consecutive
short beeps
After the program has started, the time
remaining is updated every minute.
NOTE: This option can change if
machine is not starting, once the delay
period is expire and machine start its
normal operation, this option will
disable.
17