Enviro C-10100 - Manual (Page 6)

EXPLODED VIEW S.I.T PILOT ASSEMBLY
To remove pilot injector :
Remove the two screws that hold
the pilot assembly to the burner
control assembly.
Lift the assembly straight up being
careful not to damage any
components.
Using a 10 mm wrench undo the
securing nut on pilot tubing and pull
tubing down to access injector.
Being careful not to damage the
ceramic spark electrode.
Replace the injector and reinstall
the pilot tubing, always to perform a
gas leak test before lighting the
pilot assembly.
The number on the side of the
injector will determine the size. This
number is in millimeters.
PILOT HEAD
THERMOPILE
PILOT INJECTOR
SPARK ELECTRODE
THERMOCOUPLE
Sherwood Industries Ltd. ENVIRO PAGE 4