Wolf 36 Inch Pro-Style Gas Rangetop Installation Guide - Manual (Page 3)

wolfappliance.com | 3
Rating plate location
RATING PLATE
Specifications
Planning Information
When installing against a combustible surface, a minimum
5"
(127) riser is required for model SRT366, and a minimum
10" (254) riser is required for 36" and 48" sealed burner ran-
getops with a charbroiler or griddle. Follow all minimum
clearances to combustible surfaces shown in the illustra-
tion on page 5. Models SRT362W and SRT484W cannot be
installed against a combustible surface.
Electrical Requirements
Installation must comply with all applicable electrical codes.
Locate the electrical supply within the shaded area shown
in the illustration on page 5. A separate circuit servicing
only this appliance is required. A ground fault circuit inter-
rupter (GFCI) is not recommended and may cause inter-
ruption of operation.
ELECTRICAL REQUIREMENTS
Electrical Supply grounded, 110/120 VAC, 60 Hz
Service 15 amp dedicated circuit
Receptacle 3-prong grounding-type
Power Cord 6' (1.8 m)
Product Information
Important product information, including the model and
serial number, are listed on the product rating plate. The
rating plate is located on the bottom of the control panel,
at the far right. Refer to the illustration below.
If service is necessary, contact Wolf Factory Certified
Service with the model and serial number. For the name of
the nearest Wolf Factory Certified Service or for questions
regarding the installation, visit the Product Support section
of our website, wolfappliance.com, or call Wolf Customer
Care at 800-222-7820.