Electrolux EWD 1409 I - Manual (Page 6)

1 Detergent dispenser drawer
The programme chart is in the interior part of the
drawer.
2 M
AINS
-
ON
light
This light comes on when the ON/OFF button is
pressed, and goes out when it is pressed again.
3 ON/OFF button
Press this button to switch the machine on. Press it
again to switch the machine off.
Programme Option buttons
Depending on the programme, different functions can
be combined. These must be selected after choosing the
desired programme and before depressing the
Start/Pause button.
When these buttons are pressed, the corresponding pilot
lights come on. When they are pressed again, the pilot
lights go out.
If an incorrect option is selected, the corresponding
pilot light flashes for about 2 seconds and the message
Err is displayed.
4 “Prewash” button
The machine performs a prewash cycle at 30°C max
before the main wash. The prewash cycle ends with a
short spin at 650 r.p.m. in programmes for Cotton and
Synthetics, and with emptying of the water for
Delicates.
This option is not available with the (Wool)
/Handwash programme and Miniprogram.
For use when washing heavily soiled laundry.
6
The Control Panel
1 2 3 4 5 9 6 7 8 1011
12
13 14
Off 95° Miniprogram
Easy Iron
Drying
Drying
Spin
Drain
Rinses
Cotton
Synthetics Delicates
Handwash
Rinses
Prewash
Wash
Spin
End
Rinse Hold
Drain
EWD 1409 I
Prewash Quick
wash
Spin
speed
Night
Cicle
Sensitive Drying
Time
Delay
start
Start/
Pause
1400
1200
900
700
Drying
40°
40°
30°
60°
E40°
30°
60°
40°
E60°
E60°
40°
30°
30°
5 “Spin speed” button
Press this button to reduce the maximum speed of the
final speed proposed by the machine for the selected
programme or to select position
(Rinse Hold).
The light corresponding to the selected option
illuminates.
The following speeds are available for the different
fabrics:
• Cotton, linen: 700/900/1200 max 1400 r.p.m.
• Synthetics and Handwash/( Wool) :
700 max 900 r.p.m.
• Delicates and Miniprogram : 700 r.p.m.
The light corresponding to the selected option
illuminates.
Rinse Hold
When Rinse Hold option is selected, the last rinse
water is not emptied out, to prevent the fabrics from
creasing. When the programme has finished, the light
of the
Start/Pause button goes out, the Rinse Hold and
“End” pilot lights in the programme progress display
are alight to indicate that the water must be emptied
out.
To empty out water there are 2 possibilities:
• Select programme “Drain”:
The water is emptied out without spinning.
• Select programme “Spin”: reduce eventually the spin
speed by means of the relevant button and then
depress the
Start/Pause button.
The water is emptied out and the laundry is spun at
the selected spin speed.
Attention! Before selecting programmes Drain or
Spin, the selector dial has to be positioned on Off
position (reset).
The Rinse Hold option CANNOT be selected for
the automatic Washing & Drying programme.