beautypg.com

Operating sequence, Load the laundry, Measure out the detergent and the fabric softener – Electrolux EWD 1409 I User Manual

Page 11: New jetsystem» wash, Switch the machine on, Select the required programme, Washing only

background image

11

Operating Sequence

Washing only

Before the first wash, we recommend that you run a
cotton cycle at 95°C, without any laundry in the
machine, to remove any manufacturing residue from the
drum and tub.
Pour 1/2 a measure of detergent into the main wash
compartment

of the dispenser drawer and start the

machine.

1. Load the laundry

Open the door by pulling the door handle outwards.
Place the laundry in the drum, one item at a time,
shaking them out as much as possible. Close the door.

2. Measure out the detergent

and the fabric softener

Pull out the dispenser drawer until it stops.
Measure out the amount of detergent required and pour
it into the main wash compartment

.

If you have selected the

PREWASH

option, pour detergent

into the compartment marked

.

If required, pour fabric softener into the compartment
marked

(the amount used must not exceed the

“MAX” mark in the drawer). Close the drawer gently.

«NEW JETSYSTEM» wash

As the Jetsystem is flexible and adjusts water intake
according to wash load size it is not possible to give you
exact recommandations as to the amount of detergent
that should be used for any one wash.

P0005

P0006

P0004

Therefore we recommend that you use approximately
1/3 less than the detergent manufacturer recommends on
the packet or bottle, making the appropriate allowances
for soft or hard water, and light or heavy soilage of
clothes. If you have judged the amount correctly you
should expect to see a soft sudsy liquid during the wash.
It is not necessary to have a head of lather on the water.

3. Switch the machine on

To switch the machine on, press the O

N

/O

FF

button: the

mains-on light comes on. The display will show three
flashing dashes or a blinking zero.

If the programme selector dial is on the Reset Off
position, three flashing dashes will be displayed. If the
programme selector dial has been left on a wash
programme position at the end of the previous washing
cycle, a flashing zero appears on the display.

4. Select the required programme

Turn the programme selector dial to the desired
position: the lights corresponding to the different phases
making up the selected programme light on.

The display shows the duration of the programme.

2.05

Rinses

Prewash
Wash

Spin

End

Rinse Hold

Drain

Drying

Off

95°

Miniprogram

Easy Iron

Drying

Drying

Spin

Drain

Rinses

Cotton

Synthetics

Delicates

Handwash

40°

40°

30°

60°

E40°

30°

60°

40°

E60°

E60°

40°

30°

30°

---

0