Epson A881391 - Manual (Page 16)

Follow these steps to connect the monitor to your computer:
1.
2.
3.
4.
5.
6.
Make sure the monitor, computer, and any peripheral
devices are turned off.
Turn the monitor around so the back of the monitor is
facing you.
Remove the plastic covers on the video interface cable
connectors and plug the cable into the VGA connector
shown below. Tighten the two screws on the cable
connector.
AC power connector V G A c o n n e c t o r
Plug the other end of the video cable into the video
connector on the back of the computer and tighten the two
screws on the cable connector.
Plug the power cord into the AC receptacle on the back of
the monitor.
Plug the other end of the power cord into a properly
grounded wall outlet.
8 14” Super VGA Color Monitor