DCS 20 Inch Built-in Outdoor Storage Drawer: Single Drawer Installation Instructions - Manual (Page 8)

8
7a DISCARD PACKAGING
Recycle responsibly
Model may vary from illustrations shown
8a REMOVE ALL DRAWERS TO ACCESS SCREW HOLE LOCATIONS
Inspect the product(s) to verify that there is no shipping damage.
If any damage is detected, call the shipper and initiate a damage claim.
DCS by Fisher & Paykel is not responsible for shipping damage.
NOTE: Do not discard any packing material until the unit has been inspected.
Operate the drawers to be sure they glide smoothly.
Examine the fronts to be sure there are no dents or scratches or discoloring.
INSTALLING DRAWER UNITS, WASTE BASKET
To remove the drawer(s)
1 Remove the drawers by pulling them
out until the slider latch is visible.
2 Carefully push the latch down on the
left side, while lifting up the latch on
the right side.
3 Pull the drawer out of the frame.
Note: to prevent damage to surfaces, place
the drawers on a stable surface on a
protective towel or table cloth.
Left Slider latch
Right Slider latch