DCS 20 Inch Built-in Outdoor Storage Drawer: Single Drawer Installation Instructions - Manual (Page 16)

16
7c
9c
DISCARD PACKAGING
OPTIONALLY ATTACH BOTTLE HOLDER
(PURCHASED SEPERATELY)
TO BEVERAGE CHILLER
Recycle responsibly
Model may vary from illustrations shown
Inspect the product(s) to verify that there is no shipping damage. If any damage is detected, call the
shipper and initiate a damage claim. DCS by Fisher & Paykel is not responsible for shipping damage.
NOTE: Do not discard any packing material until the unit has been inspected.
Examine the product to be sure there are no dents or scratches or discoloring.
8c PREPARE THE CAVITY
Ensure the base of the cavity is level, square and able to
support the weight of the product when full.
Any cabinet and/or ground preparation must be completed
prior to installation.
All support structures must be constructed of materials
resistant to moisture damage.
Do no use harsh products (acid, solvent, sealers) around
this product.
For installation with the Bottle holder (purchased
separately), the cutout must extend to the front of the
cabintry, allowing space for the bottle holder (as shown).
CUTOUT WITHOUT
BOTTLE HOLDER
CUTOUT WITH
BOTTLE HOLDER
INSTALLING BEVERAGE CHILLER / BOTTLE HOLDER (PURCHASED SEPERATELY)
1 Fit the bottle holder onto the front of the Beverage chiller.
2 Attach the bottle holder to the Beverage chiller with the screws provided.
3 Unwrap the drip tray and fit in the bottom of the bottle holder.