Insert product into cavity & secure – DCS 20 Inch Built-in Outdoor Storage Drawer: Single Drawer Installation Instructions User Manual
Page 10
10
10a
INSERT PRODUCT INTO CAVITY & SECURE
1
With the help of an assistant, lift the unit and slide it into the cabinet cutout along the supports. Adjust for level and fit.
2
Locate the mounting holes (front and rear of base on each side).
Single Drawer TDS1-20 only:
If you find the rear base screw hole locations inaccessible, you may screw through the rear chassis panel into the support behind the unit.
3
Secure the unit using screws suitable for the type of cabinetry materials used. We recommend using all the shown hole locations for securing.
TDD1-20, TDT1-20 & TB1-20 ONLY
Alternatively screw
through rear chassis panel
into support behind
Refer to Step 9a for screw
mounting hole positions
Refer to Step 9a for screw
mounting hole positions
TDS1-20 ONLY