LG 50 Pint Smart Dehumidifier Owner's Manual - Manual (Page 23)

22 TROUBLESHOOTING
ENGLISH
Call for service immediately in the following situations.
1 Power cord is too hot or damaged.
2 The product continues to operate when the water bucket is full, overflowing the bucket.
Problem Possible Cause Solutions
Water is draining
out of the hole at
the side of the
appliance when the
pump hose is
connected. - The drainage adapter was not
removed when the pump hose was
connected.
- The drainage adapter is only for
use with a garden hose for
continuous draining. If using the
pump, remove the drainage
adapter to allow the water to drain
into the water bucket rather than
out the drainage adapter.
There is water left
in the water bucket
even though the
pump is enabled. - The pump does not run
continuously. The pump is
activated only when the water
bucket is full.
- The pump does not completely
empty the water bucket.
- This is normal. The pump will
activate once the water bucket is
full. Once the pump stops, there
may be water left in the water
bucket. To avoid odor, clean the
water bucket at least once a week.
The pump starts
running after 3
minutes when the
water bucket is
removed. - The pump is enabled. - Disable the pump by pressing the
Pump button before removing the
water bucket for cleaning.