LG 50 Pint Smart Dehumidifier Owner's Manual - Manual (Page 10)

OPERATION 9
ENGLISH
Dehumidifying
1 Press to turn on the power.
- It takes 30 minutes of continuous
operation to reach the desired humidity
level the first time the product is used.
- The display shows the current humidity
level.
2 Press / to change humidity.
- The desired humidity level can be set in
5-percent increments from 30-80 %.
- The display shows the desired humidity
level while it is being set, then reverts to
the current humidity level after 5 seconds.
- The current humidity level is displayed in
5-percent increments from 25-90 %.
If the humidity level is outside the range,
the display continues to show either 25 %
or 90 %.
3 Press to change the fan speed.
The fan speed has two levels: low or high.
4 Press to turn off the product.
Setting the Timer
The Timer function turns the product off
automatically after a set time.
1 Empty the drain water bucket. Press to
turn on the power.
2 Press to set the automatic shut off
time.
- Press the button repeatedly to increase
the time until shut off in 1-hour
increments up to 12 hours.
3 Press to cancel the Timer function.
- Press the Timer button repeatedly until
the Timer On light turns off.
Timer function
Various kinds of reservation including the
power on/off can be made by the LG
SmartThinQ application. (Execute SmartThinQ
Application → Select the dehumidifier product
→ Make reservation)
- For more detailed description on the use of
LG SmartThinQ, refer to the Using the Smart
Functions section.
- You can set the timer time through app.
- You can set the timer function only through
LG SmartThinQ app.
NOTE
!
• If the product is restarted immediately
after being shut down, to protect the
compressor there is a 3-minute delay
until the compressor begins operating.
• It is normal for the compressor to cause
the product to vibrate while starting or
stopping.
NOTE
!
Empty the drain water bucket before
setting the Timer function.
If the water bucket becomes full during the
Timer function, the Bucket Full light goes
on and dehumidification stops.
The Timer Function icon lights up
when the Timer function is set
through the app.