LG Signature Series TurboSteam Series 29 Inch Electric Smart Dryer Owners Manual - Manual (Page 46)

46
MAINTENANCE
Regular Cleaning
W WARNING
To reduce the risk of fire, electric shock, or personal
injury when using this appliance, follow basic
precautions, including the following:
t6OQMVHUIFESZFSCFGPSFDMFBOJOHUPBWPJEUIFSJTL
PGFMFDUSJDTIPDL Failure to follow this warning can
cause serious injury, fire, electrical shock, or death.
t/FWFSVTFIBSTIDIFNJDBMTBCSBTJWFDMFBOFSTPS
TPMWFOUTUPDMFBOUIFXBTIFS They will damage the
finish.
Cleaning the Exterior
Proper care of the dryer can extend its life.
The outside of the machine can be cleaned with warm
water and a mild, nonabrasive household detergent.
Immediately wipe off any spills with a soft, damp cloth.
Cleaning the Interior
Wipe around the door opening and seal with a soft,
damp cloth to prevent lint and dust buildup that could
damage the door seal.
Clean the window with a soft cloth dampened with
warm water and a mild, nonabrasive household
detergent; then wipe dry.
The stainless steel drum can be cleaned with a
conventional stainless steel cleaner, used according to
the manufacturer’s specifications.
Never use steel wool or abrasive cleansers; they can
scratch or damage the surface.
Cleaning Around and Under the Dryer
Vacuum lint and dust from around the dryer and
underneath it regularly. Vent ductwork should be
checked for lint buildup and cleaned at least once per
year. If any noticeable reduction in airflow or drying
performance occurs, immediately check ductwork for
obstructions and blockages.
Maintaining Ductwork
Vent ductwork should be checked for lint buildup
and cleaned at least once per year. If any noticeable
reduction in airflow or drying performance occurs,
immediately check ductwork for obstructions and
blockages. Contact a qualified technician or service
provider.
Cleaning the Lint Filter
Always clean the lint filter after every cycle.
To clean, open the dryer door and pull the lint filter
straight up. Then:
1. Roll any lint off the filter with fingers, or
2. Vacuum the lint filter, or
3. If the lint filter has become very dirty or clogged with
fabric softener, wash the lint filter in warm, soapy
water and allow to dry thoroughly before reinstalling.
NOTE
NEVER operate the dryer without the lint filter in
place. NEVER operate the dryer with a wet lint filter.
NOTE
Do not use methylated spirits, solvents, or similar
products.
Never use steel wool or abrasive cleansers; they can
damage the surface.
MAINTENANCE
Lint
Filter