Warning – LG Signature Series TurboSteam Series 29 Inch Electric Smart Dryer Owners Manual User Manual

Page 19

ENGLISH

3FWFSTJOHUIF$BCJOFU$PNQPOFOUT

1. Remove the two screws and the latch assembly from

the left side of the opening.

2. Rotate the latch assembly and remount it on the right

side of the opening with the two screws.

3. Switch the two caps. Untie the twist tie and remove

the small cap from the side of the wire harness on the
top right of the cabinet. Make sure the wire harness
does not slip back into the cabinet.

4. Remove the left cap by gently prying it up with a flat

blade screwdriver, being careful not to scratch the
paint. Disconnect the wire harness attached to the
cap by pressing the tabs on either side.

5. Attach the left cap to the wire harness on the top right

of the cabinet. Snap the cap into place.

6. Attach the twist tie and the small cap removed in step

1 to the side of the wire harness on the bottom left of
the cabinet. The wire harness will be attached to the
harness in the door.

7. Unscrew the four decorative screws from the left side

of the cabinet and insert them into the matching
holes on the right side of the cabinet.

Latch

Cap L

WARNING

#FTVSFUPTVQQPSUUIFXFJHIUPGUIFEPPSXIJMF

inserting the hinge screws.

1SFQBSJOHUP3FNPVOUUIF%PPS

1. While supporting the door, move the door into

position with the hinge on the left side.

2. Connect the wire harness from the hinge to the

connector on the lower left side of the cabinet.

Harness
Connector

Hinge Hole

.PVOUJOHUIF%PPS

1. Align the hinge with the mounting holes.
2. While supporting the door, fasten the four hinge

screws.

'JOBM$IFDL

1. Check that the door closes and latches properly.

INSTALLATION