Fisher & Paykel 24 Inch Condensing Dryer Install Guide - Manual (Page 36)

34
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSES WHAT TO DO
Greasy spots
on clothes.
Improper use of fabric
softener. Follow directions on fabric
softener package.
Drying dirty items with
clean ones. Use your dryer to dry only clean items.
Dirty items can stain clean items and
the dryer.
Clothes were not
completely clean. Sometimes stains which cannot be seen
when the clothes are wet appear after
drying. Use proper washing procedures
before drying.
Lint on clothes. Lint filter is full. Clean lint screen before each load.
Improper sorting. Sort lint producers (like chenille) from
lint collectors (like corduroy).
Static electricity can
attract lint. See suggestions in this section under
‘Static occurs’.
Overloading. Separate large loads into smaller ones.
Paper, tissue, etc,
left in pockets. Empty all pockets before
laundering clothes.
Static occurs. No fabric softener
was used. Try a recommended fabric softener.
Overdrying. Try a recommended fabric softener.
Adjust setting to a lower dryness level.
Synthetics, permanent
press and blends can
cause static. Try a recommended fabric softener.
Collars and
waistbands
still wet at end
of cycle.
The dryness monitor
senses that the body of
the clothes is dry. Choose ‘Time Dry’ to dry damp
collars and waistbands. In the future,
when drying a load with collars
and waistbands, choose a higher
dryness level.
Slight variation
in metallic color.
This is normal. Due to the metallic properties of paint
used for this unique product, slight
variations of color may occur due to
viewing angles and lighting conditions.
Dryer continues
to tumble.
‘Wrinkle Free’, ‘Extra’
was selected. Ensure ‘Wrinkle Free’, ‘Extra’ option is
not selected.