Fisher & Paykel 24 Inch Condensing Dryer Install Guide - Manual (Page 17)

15
INSTALLATION INSTRUCTIONS
4 Over the edge of a wash basin:
The drain hose must be placed lower
than 58” (147cm). To keep the drain
hose spout bent, use the plastic hose
guide as supplied with the washer.
Secure the guide to the wall with a
hook or to the tap with a piece of string
to prevent the drain hose from moving.
5 Assemble the drain hose and the hose
guide and fix them with the cable-tie.
Back view
A
A
B
Drain hose Hose guide
Cable ties
58”
(147cm)
Max.
EN
Connecting the drain hose
Draining water without using the water tank
You can use the dryer without using the water tank
by following the procedures below.
To connect the drain hose:
1 Disconnect the drain hose A.
2 Connect the drain hose A to the other hole.
3 Connect accessory hose B (long drain hose) adjacent
to hose A.
● ●
When connecting hose B , take care that the height
of the hose does not exceed 58” (147cm).
● ●
After connecting the drain hose, you can now
directly drain the condensed water to a standpipe
or washstand.
Do not push the drain hose in the
standpipe any further than 4” (10cm).
Pushing the drain hose further in the
standpipe can cause leaking.